You have to have the factory code to progam a new code in one code is perminantly programed the sedond code can be entered after the original code is put in. Once the program CODE has been saved the programming mode is excited by pressing any key.if the new code is incorrect this process should be repeated.the programming mode can be excited at any time by pressing door alarm key for 3 seconds or will exit if unattended for 4 minutes.good luck but will beep ,(the unit will not run with a program code of 0000 ,). Once the desired program code is entered press & hold the freezer temperature down keypad until the program CODE begins flashing indicating it has been u attempt to enter an invalid code the control will not save the new code. the decimal point indicates the selected digit press the freezer temperature Up keypad to select next digit. NOTE.IF THE PROGRAM code is correct the programming mode is excited by pressing door alarm keypad for 3 seconds.7.press the refrigerator temperature up keypad or refrigerator down keypad to change the digit value with each key press. 4.the control will DISPLAY PE to indicate the programming mode 5.entry is confirmed by pressing the freezer temperature down keypad once more.6 the control will display the current program CODE this program should be validated with the program CODE printed on the unit serieal plate. 1 press & hold the door alarm keypad.2 press & hold freezer temperature down keyboard within 3 seconds.3 release the door alarm alarm keypad and wait 3 seconds.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |